ViewTube

Milestone video of the drone I'm making from scratch, using a custom RTOS (derived from classes I took at university). This project ...

In this video, we build the foundation for integrating MAVLink into a custom flight controller and connecting it to QGroundControl.

Is standard PID tuning dead? In this video, I replace the standard Betaflight PID controller with an Active Disturbance Rejection ...

Most flight controllers are black boxes. So I built my own, fully open source, running on the cheapest capable microcontroller I ...

This white paper proposes a paradigm shift in aviation by replacing traditional linear calculus in flight computers with non-linear ...

UAV #DroneControl #MATLAB Get the book on Amazon: https://a.co/d/030e4I4g Take your MATLAB drone programming ...

Audio recorded by ATC App. Get their iOS app and enjoy all their features. Use the Promo Code VAS1 or follow this link for a good ...

A quick video showing you how I built my new Atomrc Thresher Shark fpv fixed wing drone. In this video I show you all the steps I ...

I have always dreamed of building a custom quadcopter drone with my custom fine-tuned flight controller firmware and cascaded ...

Welcome to my channel! In this video, I built a DIY drone using FC F722| and drone components. This project demonstrates drone ...

This is a flight test of my custom Arduino-based quadcopter powered by an Arduino flight controller inspired by Joop Brokking's ...

If you're tired of traditional PID tuning and want a flight controller that actively estimates and cancels out wind gusts and ...

Most flight controllers today run on software developed outside India. A year ago, we asked a simple question: What if we built the ...

0:00 Introduction and Objectives 2:18 Software requirements 3:24 Simulation of Drone 5:28 Hardware and their Uses 6:45 ...

Meet AURA — a custom-built, micro robotic bionic RC butterfly! Unlike traditional RC planes with propellers, AURA is a ...

... DroneCAN Serial Tunnel, which forwards serial communication between the flight controller and DroneCAN peripheral devices.

How to make an airplane controller in unity, including physics and aerodynamics, using AddForce and AddTorque functions.

In Episode 3 of the FlyCore hands-on series, we take AI-assisted drone development one step further. This time, we use AI to help ...

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: ...